• CDG on bridge
CDG on bridge

Bakker Sliedrecht successfully develops first generator protection for dual fuel ships

20 March 2019

Bakker Sliedrecht has been the first to develop a generator protection system (CDG-protection) for dual fuel vessels which operate with a dynamic positioning system (DP) 2 and 3. The system has been successfully tested by classification society DNV GL.

The Common Diesel Generator protection system the system integrator developed will be deployed for the first time on an offshore heavy lift vessel, which is currently under construction. The ship is equipped with a power plant of 4 generators of 10 MW each, which run on both diesel and LNG. Generator protection is essential to prevent a blackout or failure in the power plant, causing the ship to lose its position during operations.

Vessels that sail in DP 2 or 3 mode have to maintain their position at all times, even in case of
failures or malfunctions in the fuel system, a diesel, a generator, the switchboard, or
the control system. To prevent such malfunctions power plants are usually divided into independent isles. However, this makes generators run inefficient which is undesirable cost- and environmentally wise. That is why ships nowadays prefer to operate with generators in parallel operation.

To prevent these from interfering with each other, a generator safety system is necessary. Bakker Sliedrecht’s CDG-protection system uses software to detect and disable an ‘unhealthy’ generator before it can affect the ‘healthy’ generators, making the entire power plant unstable. For power plants equipped with dual fuel generators, this is extra complex because duel fuel engines behave differently than diesel engines and can unexpectedly switch from gas to diesel.

Without generator protection, a complex DP vessel will therefore not receive a certificate to operate in DP2 or DP3 closed bus mode. Bakker Sliedrecht started in 2017 with the further development of its own CDG protection system for complex work vessels. The system is now so far developed that it can be deployed in the heavy lift vessel. During the last months, it has been extensively tested in a test set-up of four generators. The system had been tested against  the requirements as formulated in the ‘DNV GL Rules: DNV-RP-D102 closed busties’ with underlying rules ‘Part 4: Ch8 Electrical installations & Ch9 Control and monitoring systems’. The system has passed these tests with flying colours even under dual fuel conditions.  

According to the classification society, the heavy lift vessel will be the first dual fuel DP2 ship to be classified with a generator protection system. ,,So you can say that we are ground-breaking. Our technology will prevent the ship from getting out of position,” says Paul Bracké, technology manager of Bakker Sliedrecht. ,,That requires not only the first dual fuel generator protection system, but also a good power management and zone security system, including an experienced operator. Bakker Sliedrecht was able to combine all the required knowledge and has therefore achieved a world-class result."

nieuws afbeelding Bakker Sliedrecht again involved in building offshore support vessel Bibby WaveMaster Horizon by Damen
17 September 2018

After the successful commissioning of Service Operations Vessel (SOV) Bibby WaveMaster 1, Damen Shipyards started...

nieuws afbeelding Bakker Sliedrecht and RH Marine partner up to boost scale and innovation
29 August 2018

SLIEDRECHT/SCHIEDAM – Leading maritime system integrators of electrical and automation systems Bakker...

nieuws afbeelding Bakker Sliedrecht to extend lifetime of two NMDC cutter suction dredgers
16 July 2018

Bakker Sliedrecht has received the order to extend the lifetime of the electrical installations of two cutter...

nieuws afbeelding Bakker Sliedrecht coordinates innovative fall pipe vessel Bravenes
24 May 2018

Advanced technology from the Netherlands implemented in China

This week, international...